Installation Instructions

ManualsBrandsToro ManualsAttachmentsHorn Kit, Groundsmaster 4000 or 4100 Series Rotary Mower

FormNo.3399-118RevA

HornKit

Groundsmaster

4000or4100SeriesRotaryMower

ModelNo.31511

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Horn1

Hornswitch1

Hornbutton(rubber)

Bolt(5/16x3/4inch)

Flangenut(5/16inch)

Installthehorn.

Nopartsrequired

–

Testthehornfunction.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

PreparingtheMachine

NoPartsRequired

Procedure

1.Movethemachinetoalevelsurfaceandsettheparking

brake.

2.Shutoffthemachineandremovethekey.

CAUTION

Ifyouleavethekeyintheignitionswitch,

someonecouldaccidentlystarttheengineand

seriouslyinjureyouorotherbystanders.

Removethekeyfromtheignitionswitch

beforeyoudoanymaintenance.

3.Disconnectthebattery;refertoyourOperator’sManual.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3399-118*A

Summary of content (2 pages)

PAGE 1
Form No. 3399-118 Rev A Horn Kit Groundsmaster® 4000 or 4100 Series Rotary Mower Model No. 31511 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine.
PAGE 2
2 1 Installing the Horn Parts needed for this procedure: 1 Horn 1 Horn switch 1 Horn button (rubber) 1 Bolt (5/16 x 3/4 inch) 1 Flange nut (5/16 inch) g021715 Figure 2 1. Horn switch 2. Horn button 3. Secure the horn switch to the tower by threading on the rubber horn button (Figure 2). Procedure 4. Locate the wire-harness connectors inside the steering column tower. 1.