Installation Instructions

ManualsBrandsToro ManualsAttachmentsLicense Plate Kit, Groundsmaster 4500-D, 4700-D or Reelmaster 7000-D Traction Unit

Table Of Contents

.
- 1 Drilling the Mounting Holes in the Rear Bumper for the License Plate
- 2 Installing the License-Plate Bracket

FormNo.3399-302RevA

LicensePlateKit

Groundsmaster

4500-D,4700-D,orReelmaster

7000-DTraction

Unit

ModelNo.31574

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Drillthemountingholesintherear

bumperforthelicenseplate.

Platelight1

Platebracket1

Screw(#10x5/8inch)

Locknut(#10)

Self-tappingscrew(5/16x1/2inch)

Installthelicense-platebracket.

MediaandAdditionalParts

Description

Qty.

Use

Installationinstructions1

Readtheinstructionsbeforeinstallingandoperatingthekit

Partscatalog1

Usetoreferencepartnumbers

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3399-302*A

Summary of content (2 pages)

PAGE 1
Form No. 3399-302 Rev A License Plate Kit Groundsmaster® 4500-D, 4700-D, or Reelmaster® 7000-D Traction Unit Model No. 31574 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty.
PAGE 2
1 2 Drilling the Mounting Holes in the Rear Bumper for the License Plate Installing the License-Plate Bracket Parts needed for this procedure: No Parts Required Procedure 1. Park the machine on a level surface, engage the parking brake, and remove the key from the ignition. 2. Using the dimensions shown in Figure 1, locate and drill 2 holes (9/32 inch) through the outside wall of the rear bumper.