Installation Instructions

ManualsBrandsToro ManualsAttachmentsTUV 20 KPH Speed Decal Kit, Groundsmaster 4500-D, 4700-D or Reelmaster 7000-D Traction Unit

FormNo.3399-328RevA

TUV20KPHSpeedDecalKit

Groundsmaster

4500-D,4700-D,orReelmaster

7000-DTraction

Unit

ModelNo.31578

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Note:Beforeinstallingthiskit,youmustinstalltheCELightKit(ModelNo.30491or31573)forproperfunctionofthiskit.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Plate2

Decal4

Hex-headscrew(1/4x2-1/2inches)

Locknut(1/4inch)

Installthedecal-mountingplates.

MediaandAdditionalParts

Description

Qty.

Use

Installationinstructions1

Readinstructionsbeforeinstallingandoperatingthekit

Partscatalog1

Usetoreferencepartnumbers

InstallingtheDecal-Mounting

Plates

InstallingtheDecal-MountingPlates

ForMachineswiththeCELightKit

PreviouslyInstalled

1.Usinga9/32-inchdrillbit,drill2holesintoeach

light-kitbracket(Figure1).

Note:Thedimensionsfromthemountingsurface

totheholesandthespacingbetweenthe2holesare

asfollows:

•Distancefromthemountingsurfacetohole1:

23.5cm(9-1/4inches)

•Distancefromthemountingsurfacetohole

2:27.9cm(11inches)

•Distancebetweenthe2holes:4.45cm(1-3/4

inches)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3399-328*A

Summary of content (2 pages)

PAGE 1
Form No. 3399-328 Rev A TUV 20 KPH Speed Decal Kit Groundsmaster® 4500-D, 4700-D, or Reelmaster® 7000-D Traction Unit Model No. 31578 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Note: Before installing this kit, you must install the CE Light Kit (Model No. 30491 or 31573) for proper function of this kit.
PAGE 2
Figure 1 Right side shown Figure 3 Right side shown 2. Align the plates with the drilled holes in the light-kit brackets (Figure 2). 1. Plate 3. Light-kit bracket 2. Locknuts (1/4 inch) 4. Hex-head screws (1/4 x 2-1/2 inches) 4. Apply the decals to the outward-facing surface of the plates (Figure 4). Figure 2 Right side shown 1. Plate 2. Light-kit bracket 3. Holes Figure 4 Right side shown 3.