Installation Instructions

ManualsBrandsToro ManualsAttachmentsLED Work Light Kit, Groundsmaster 3200 or 3300 Series Traction Unit with ROPS

FormNo.3436-611RevA

LEDWorkLightKit

Groundsmaster

3200or3300SeriesTractionUnitwithROPS

ModelNo.31997

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Prepareforinstallation.

Lightmount2

U-bolt6

Locknut(3/8inch)

Flange-headbolt(5/16x1inch)

FlangeLocknut(5/16inch)

Worklightassembly4

Switchbracket

Switch

Holeplug1

Installtheworklightsandtheswitch.

Longcabletie6

Shortcabletie

Worklightharness1

Connectthewireharness.

PreparingforInstallation

NoPartsRequired

Procedure

Note:Retainallremovedpartsforlaterinstallation

unlessotherwisenoted.

1.Parkthemachineonalevelsurface,lowerthe

attachment,shutofftheengine,engagethe

parkingbrake,andremovethekey.

2.Disconnectthenegative(-)batterycable

fromthebattery;refertotheelectricalsystem

maintenancesectionofthetractionunit

Operator’sManual.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3436-611*A

Summary of content (4 pages)

PAGE 1
Form No. 3436-611 Rev A LED Work Light Kit Groundsmaster® 3200 or 3300 Series Traction Unit with ROPS Model No. 31997 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Qty.
PAGE 2
Installing the Work Lights and the Switch Parts needed for this procedure: 2 Light mount 6 U-bolt 12 Locknut (3/8 inch) 4 Flange-head bolt (5/16 x 1 inch) 4 Flange Locknut (5/16 inch) 4 Work light assembly 1 Switch bracket 1 Switch 1 Hole plug g307624 Figure 2 1. Locknut (5/16 inch) 2. Work light assembly 3. Install the switch and the hole plug to the switch bracket as shown in Figure 3. 4.
PAGE 3
Connecting the Wire Harness Parts needed for this procedure: 6 Long cable tie 2 Short cable tie 1 Work light harness g307639 Procedure 1. Figure 5 Route the work light wire harness and loosely secure it to the ROPS with long cable ties as shown in Figure 4. 1. Work light connector 3. Important: Route the wire harness away from any sharp, hot, or moving parts; secure it with cable ties as needed. 2.
PAGE 4
. Operation Connect the loose single-wire socket to the loose tab connector on the main harness (Figure 7). Using the Lights To illuminate the work lights, press up on the light switch installed to the front of the ROPS. g307611 Figure 7 1. Tab connector on the main 2. Socket on the work light harness harness 5. Connect the single-wire ring terminal at the end of the work light harness to the negative (-) terminal of the battery. 6.