Service Manual

ROCKER
SNAP RING
VT-1050
FIGURE 11-1. ROCKER ARM ASSEMBLY
CYLINDER HEAD
Disassembly
Torquing or removlng the cylinder
head when hot (above
100F [37C] wlll result
in head damage.
Allow the head to cool to below
100F (37C) before torquing or removlng.
Refer to Figure 11-2. The engine must be at room
temperature before starting this procedure. Re-
move the valve cover capscrews and valve cover.
Remove the spark plug. Remove the rocker arm as-
sembly by unscrewing bolt holding the assembly
on. Pull out the push rods. Remove the remaining
cylinder head screws and remove the cylinder
head. Remove the cylinder head gasket.
ROCKER ARM ASSEMBLY
RETAlNlNG BOLT
NUMBERS INDICATE CYLINDER
HEAD BOLT TORQUE SEQUENCE
c-1120
FIGURE 11-2. CYLINDER HEAD BOLTS