Operator's Manual

7
Note: Remove parts from shipping container and lay out all
hardware and fasteners to ease assembly. Use loose parts
chart and illustration to identify and locate parts.
3 Unit Assembly
Figure 2
Install Drawbars to Reelmaster Cutting
Units
1. Align holes in stationary (non pivoting) drawbars with
brackets on mower crosstube. Secure each side with
1/2–13 x 2–1/2” lg. capscrew, spacer, and 1/2–13
locknut. Position capscrew heads to the inside of
brackets when mounting. Use same procedure on
remaining stationary drawbars.
Note: If Spartan mowers are to be attached, drawbar
clamps, part no. 5–1090 and mounting fasteners will be
required to mount drawbar to cross tube of mower (Fig. 3).
Contact your local Authorized Toro Distributor to order
parts or for assistance.
Figure 3
2. Install lift chain to mower with 1/8 x 3/4 cotter pin,
shackle and 3/8 x 1–1/2 clevis pin.
Install Trailing Frames
1. Align mounting holes in trailing frame with holes in
drawbar/cutting unit. Secure with 1/2–13 x 1–1/4” lg.
capscrews and 1/2–13 locknuts.
2. Install lift chain from trailing unit to mower with 1/8 x
3/4 cotter pin, shackle and 3/8 x 1–1/2 clevis pin.
Repeat assembly procedure to remaining trailingunits.
3. Connect trailing units to rear corners of center frame
with U–bolts and 1/2–13 locknuts.
4. Lubricate all moving parts of frame; refer to lubrication,
page 10.
3 To 5 Unit Conversion
Figure 4
Install Drawbars to Cutting Units
Align holes in pivoting drawbar with brackets on mower
crosstube. Secure each side with 1/2–13 x 2–1/2” lg.
capscrew, spacer, and 1/2–13 locknut. Position capscrew
head to the inside of bracket when mounting. Use same
procedure on remaining pivoting drawbar.
Install Wing Units
1. Align mounting holes in wing units with mounting
holes in drawbar/cutting units. Secure with 1/2–13 x
1–1/4” lg. capscrews and 1/2–13 locknuts.
2. Install lift chains from wing units to mower with 1/8 x
3/4 cotter pins, shackles, and 3/8 x clevis pins.
3. Attach (2) left hand and (2) right hand hinge sockets to
respective sides of center frame with 1/2–13 x 1–1/4”
lg. capscrews and 1/2–13 locknuts. The ball socket
openings should be facing toward the front of the frame.
4. Install a grease fitting into each hinge cap.
5. Install a hinge clamp bolt and lockwasher into each
hinge cap.