Operator's Manual

13
Install Reelmaster Mowers
1. Align holes in drawbar with brackets on mower
cross–tubes. Secure each side with 1/2–13 x 3–1/2” lg.
capscrew, spacer tube and 1/2–13 locknut (Fig. 15).
Note: The head of the capscrew should be positioned
inboard.
Figure 15
1. Capscrew, spacer tube &
locknut
2. Mounting bracket
Note: If Spartan mowers are to be attached, drawbar
clamps, Part No. 5–1090 and mounting fasteners will be
required to mount drawbar to front cross tube of mower.
Contact your local Authorized Toro Distributor for
assistance.
2. Secure lift bracket to #1 lift chain (rear center) with a
long shackle, clevis pin and cotter pin (Fig. 16).
Note: Make sure there are no kinks or twists in chain
before installing cutting units.
Figure 16
1. Lift bracket
2. #1 lift chain
3. Long shackle
4. Clevis pin & cotter pin
5. Capscrew & locknut
6. Spring
7. S–hook
8. Lift bail
3. Secure lift bracket to mower mounting bracket with a
3/8–16 x 1–1/2” lg. capscrew and 3/8–16 locknut
(Fig. 16). Use bottom mounting hole in lift bracket.
4. Hook spring to upper mounting hole in lift bracket and
other end of spring to lift bail with S–hook (Fig. 16).
5. On remaining mowers, secure lift chains to mower
mounting bracket with long shackles, clevis pins and
cotter pins (Fig. 17).
Note: Make sure there are no kinks or twists in chain
before installing cutting units.
Figure 17
1. Mounting bracket
2. Long shackles
3. Clevis pin & cotter pin
4. Fifth link from mower
5. Spring
6. S–hook
7. Lift bail
6. Hook spring to fifth link in chain from mower and
secure other end of spring to lift bail with S–hook
(Fig. 17).
Check Tire Pressure
Correct air pressure is 24–28 psi.