Operator's Manual

21
3. Pull off the wheel and outer bearing cone. Remove the
inner bearing cone and seal from the hub. A slot in the
hub is provided so the cone and seal can be removed
with the bearing cup. Drive against bearing cup.
4. Clean the hub with a solvent.
5. Press the new cups in the hub, being certain they are
fully seated.
6. Pack the new cones with wheel bearing grease. Coat
bearing journal and adjacent bearings in hub.
7. Grease the sealing lip and slip the new seal on the
extended race of the inner bearing cone.
8. Reassemble in reverse order of disassembly.
9. Tighten the slotted nut until the bearings bind slightly
when rotating the wheel by hand. Back off the slotted
nut to the nearest cotter pin hole and secure with a new
cotter pin.
10. Reinstall the hub caps.
Lift Arm Bushing Replacement
To replace the lift arm bushing proceed as follows:
1. Position lift arm in the down position.
2. Remove cutting unit.
3. Remove nut from end of pin (Fig. 35).
4. Remove capscrew from pin assembly.
5. Remove link between hydraulic cylinder and lift arm.
Figure 35
1. Lift arm
2. Nut
3. Pin assembly
4. Capscrew
5. Link
6. Remove pin assembly.
7. Remove bushings in lift arm.
8. Insert and size new bushings and replace pin.
9. Replace capscrew and nut.
10. Reinstall link.
11. Grease bushing with Mobilux #2 grease or equivalent.
Important It may be necessary to drive the pin
assembly out of the lift arm. Be careful not to damage
the threads.