Service Manual

T2® / T2-HP
TM
/ T3 HD
TM
27
INPUT SHAFT
Refer to Figure 19
Disassembly
1. Remove all external items previously dis-
cussed in their recommended order.
2. Remove the retaining ring (66) and dis-
card.
3. Remove the lip seal (65) and discard.
4. Remove the washer (64).
5. Remove the pump shaft (61) with pressed
on bearing (62), and the helical spring
(67).
NOTE: Remove the bearing from pump shaft
only if worn or damaged.
6. Remove the wire ring retainer (63) and
discard. Remove the bearing (62) from the
pump shaft (61).
Inspection
1. Inspect the bearing and input shaft for wear
or damage. Inspect the splines on the shaft
for possible damage. Replace if neces-
sary.
Figure 19, Input Shaft
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. Install the bearing (62), a new retaining wire
(63), and spring (67) onto the input shaft.
NOTE: Apply a light coating of grease to new
seal (65) before installing. Refer to
“Seal Kit” in the Items List on page
37.
3. Install the input shaft assembly into the main
housing.
4. Install the washer (64), seal (65) and retain-
ing ring (66) into the main housing.
66
65
64
63
62
61
67