Service Manual

T2® / T2-HP
TM
/ T3 HD
TM
31
Figure 24, Filter Assembly
FILTER ASSEMBLY
Figure 25, Pump/Motor Cylinder Block Assembly
CYLINDER BLOCKS
Refer to Figure 25
Inspect each component of the cylinder block
assemblies for wear or damage. Inspect the
cylinder blocks’ running surface for scratches.
Replace if necessary.
NOTE: During separation of the cylinder
blocks, take care not to damage the
surfaces of the pistons and block.
Apply a thin coating of oil to all compo-
nents of the cylinder block assemblies
before reassembly.
After reassembling the cylinder block compo-
nents, set aside until ready for installation of
the center section and swashplate. Refer to
pages 28 and 30.
Refer to Figure 24
Disassembly
1. Remove the magnet (28) and the lter (27).
The lter can be removed without damaging
the lter base (26).
2. Remove the deector (29).
3. Inspect the check plugs (24, 25). Remove
if necessary.
NOTE: Mark plugs before removal.
4. Inspect the lter base (26). Remove/replace
if necessary.
Inspection
1. Inspect all parts for wear or damage. Re-
place as necessary.
Assembly
1. Install the lter base, if removed.
2. Install the check plugs, if removed. Refer to
torque chart on page 15.
3. Install the deector (29).
Pistons
Thrust Washers
Cylinder Block
Springs
28
27
29
24
26
22
20
25