Service Manual

32 T2® / T2-HP
TM
/ T3 HD
TM
LH AXLE SHAFT
Refer to Figure 26
Disassembly
1. Remove all items previously discussed, in
their recommended order.
2. Remove the retaining ring (109)* and dis-
card.
3. Remove the lip seal (110) and discard.
4. Remove the outboard bushing (106).
5. Remove the axle shaft (104) in the direction
of arrow.
6. Remove the inner bushing (105).
Inspection
1. Inspect the axle shaft for wear or damage.
Replace if necessary.
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damage when installing into the bore
and over the axle shaft, apply a protec-
tive covering over the splines, sharp
corners and/or keyway of the axle shaft
(e.g., cellophane, tape, etc.). Remove
protective covering after installation.
Figure 26, Axle Assembly
101
105
100
104
*For the T3 HD transaxle, the axle
shaft retaining ring (109) is not
included.
110
106
109*
1