~ Operating& Maintenance Instructions (76.2 cmy) Side Discharge Mower 36 in. {92 cin) Rear Discharge Mower 200 Series Lawn Tractor Mowers Wheel Horse. Tractors & Riding Mowers PRINTED IN U.S.A.
MODEL AND SERIAL NUMBER A Soda! and Serial Number identifies your Toto Wheal Horse attachment. These numbers should always be retarder 1o when consulting with your dealer or factory concerning service, replacement parts, or questions you may have. [t plate is removed during repair operations i should always be replaced. For your reference, record numbers trim Model and Serial Number plate on your detachment. MOREL BERMUDIAN OOK FORWARD (IOTA SWISH LT o 818 IRELAND BOAS.
Position drive bel on mower spindle and arid pulleys. Pull on tod handle and install drive blat on PTO solute pulley and truncation on frame bracket with hairpin cotter. Level mower as described under “l Level Mower”, Adjust belt tension as described under “Drive Belt Adjustment”, 36" Mower Belt Outing ADJUSTMENTS L Cutting Height Cutting height is adjustable. Cutting height adjustment is made using height contra lever at the left rear of mower. Move lever up to raise mower. Move lever down fo lower mower.
: Side-TO-SI08 ADJUSTMENT RIGHT HAMMING ECCENTRIC Fight Hand Frame Bolt Turn blade side-to side. t Sower DECK I — Iliad ERASURE HERE LEVEL uet ack Blade Laval Adjust and secure left hand eccentric screw so that distance between right and fell blade tip ends and surface is the same. i aqua distance on blade tips 1o surface can nof be achieved, secures sift hand scenic screw and readjust and secure right hand eccentric screw 1o get equal distance.
On 30" mowers, if applicable place spacer inside of idler Remove left and right rear mower attaching hairpin cotters. block so that 1/210 1 inch (1,310 2.5cm) of red extends past Rotate locks forward, 1t up on rear of deck and release rear frame bracket. If belt slippage is experienced during seamounts. Headstall hairpin cotters in locks. son, move spring bot to rear hols, Turn front wheals il the way right.
Average lawn are usually cut at a height between 2 and 3 inches (St 7.6 ol Tall grass and weeds should be outwith mower in iis highest position, making a second pass cutting 1o height desired. Always keep mower blades sharp. Very tall or wet grass can be cut without difficulty by using a little care. Set mower in its highest cutting position and enter area in first gear. if necessary, take a cut one-half the width of mower, overlapping previously cut area on each pass.
UNDERSIDE CLEANING iris very important to clean underside of mower frequently. Accumulation of matted clippings seriously impairs mower's ability to “Sift” grass blades into cutting position and discharge clippings evenly. Matted grass clogging underside of mower is often cause of uneven cutting. Mower should be removed from tractor for cleaning.