Service Manual

4-11Power Max Service Manual
Traction Cable Adjustment
1. The traction lever should be in the full upright
position with some slack in the traction cable to
begin adjustment (Fig. 047).
2. Adjust using the turnbuckle; hold the cable to
prevent twisting (Fig. 048).
Fig 048 MVC-894X
Fig 050 MVC-892X
1. To replace the clutch cables, drain the fuel tank and
stand the machine on the auger. Remove both lower
covers (Fig. 050). The wheels and the bottom cover
can also be removed if desired.
Fig 049 MVC-895X
3. Locate the traction rod on the left side just below the
belt cover.
Adjust the cable turnbuckle until there is a slight gap
between the end of the rod and the front of the slot
(maximum 1/16” [1.5mm]). Secure the jam nut on
the turnbuckle (Fig. 049). The left hand belt cover
has been removed only for clarity.
CONTROLS
REPLACE AND ADJUST WHEEL
CLUTCH CABLES (wheel clutch
models only)
Clutch Cable Replacement