Service Manual

9-20 Power Max Service Manual

WHEEL CLUTCH

TRACTION DRIVE SYSTEM

Fig 189 MVC-890XB.jpg

11. Repair or replace defective components.

10. Remove pawl pins and pawls with from the 32-tooth

gear (Fig. 188 and Fig. 189).

Fig 188 MVC-889XWC.jpg

Fig 191 MVC-901XWC.jpg

2. With the pawls facing up and away from the hub,

slide the retainer plate onto hub. Make sure the pins

are seated ﬂ ush and the retainer plate sits ﬂ ush onto

the gear (Fig. 191).

Fig 190 MVC-902XWC.jpg

Note: Apply a light coat of SAE 30W oil to

intermediate shaft before assembly.

1. Set the 32-tooth gear on a ﬂ at surface and install

pawls. Apply a light coat of oil Toro part no. 505-5

to dowel pins then install dowel pins into the pawl

assembly (Fig. 190).

WHEEL CLUTCH REASSEMBLY