Service Manual

7-4 Power Max Service Manual

AUGER GEARBOX

11. Pull the auger forward a little, slide the pulley from

the auger gearbox input shaft and pull the key out of

the shaft. The auger assembly should pull out to the

front.

Note: If you cannot remove the pulley from the input

shaft, it will be necessary to separate the

auger and traction assemblies to get better

access to the auger pulley. See Separating the

Auger and Traction Assemblies, page 7-4.

12. Slide the bearing off each end of the auger shaft.

If this model has a pivoting scraper, it can now be

removed.

13. Remove the capscrew connecting each auger to

the auger shaft and slide the auger off the shaft

(Fig. 083).

Fig 083 MVC-900XA

14. The auger gearbox is now ready for disassembly

and repair.

Fig 085 MVC-774X

2. Remove the cover over the chute gears. Free the

chute latch cable from its clamp and disconnect the

chute latch cable (Fig. 085).

Fig 084 MVC-771X

Should you be unable to remove the pulley from the

auger gearbox input shaft, it will be necessary to

separate the auger and traction assemblies. After

performing steps 1-7 listed above, proceed as follows:

1. Disconnect the deﬂ ector cable from the deﬂ ector

(Fig. 084).

SEPARATING THE AUGER

AND TRACTION ASSEMBLIES

SECONDARY METHOD