Operator's Manual

• If a shield, safety device , or decal is damag ed, illegible ,
or lost, re pair or re place it before beginning operation.
Also , tighten any loose fasteners .
• Do not smok e while handling g asoline .
• Do not use the sno wthro w er on a roof .
• Do not touc h the engine while it is r unning or soon
after it has stopped because the engine ma y be hot
enough to cause a bur n.
• P erfor m only those maintenance instr uctions described
in this man ual. Before perfor ming any maintenance ,
ser vice , or adjustment, stop the engine , remo v e the k ey ,
and disconnect the wire from the spark plug . If major
re pairs are ev er needed, contact an A uthorized Ser vice
Dealer .
• Do not c hang e the g o v er nor settings on the engine .
• W hen storing the sno wthro w er for more than 30 da ys ,
drain the fuel from the fuel tank to prev ent a potential
hazard. Store fuel in an appro v ed fuel container .
R emo v e the k ey from the ignition switc h before storing
the sno wthro w er .
• Purc hase only g en uine T oro re placement par ts and
accessories .
Sound Pressure
T his unit has a maxim um sound pressure lev el at the
operator’ s ear of 90 dB A, based on measurements of
identical mac hines per EN 11201.
Sound Power
T his unit has a guaranteed sound po w er lev el of 107 dB A,
based on measurements of identical mac hines per EN 3744.
Vibration
T his unit does not ex ceed a hand/ar m vibration lev el of
11.4 m/s
2
, based on measurements of identical mac hines
per EN 1033.
Safety and Instructional Decals
Important: Safety and instr uction decals ar e located near ar eas of potential danger . R eplace dama ged decals.
94-2560
1. Cutting/dismemberment hazard, impeller—stay away from
moving parts; remove the key and read the instructions before
servicing or performing maintenance.
94-2561
1. Hot surface/burn hazard—keep bystanders a safe distance from
the machine.
94-2562
1. Cutting/dismemberment hazard, auger—stay away from moving
parts; remove the key and read the instructions before servicing
or performing maintenance.
94-2577
1. To engage the auger, hold the control bar against the handle.
2. To disengage the auger, release the control bar.
3