Service Manual

Single Stage Snowthrower Service Manual 4 - 5
ENGINE REMOVAL AND INSTALLATION
B. Install the crankshaft pulley. Refer to
"Crankshaft Pulley Replacement" on page 5 -
3.
C. Connect the spark plug lead wire.
D. Install the belt and side plate. Refer to
"Replacing Drive Belt" on page 5 - 1.
Complete Steps 5 through 7.
Chain Drive Units:
A. Install the crankshaft sprocket. Be certain to
align the keyway (slot) of the crankshaft
sprocket with the location key on the
crankshaft. Should the locating key on the
crankshaft show signs of wear, replace.
B. Install the chain. Refer to "Chain
Replacement" on page 5 - 25. Do Step 3.
Align and adjust the chain. Refer to
"Crankshaft Sprocket Replacement (all
models)" on page 5 - 21. Consult Steps 5
through 8.
C. Install left side plate and chainguard.
D. Connect the spark plug lead wire.
POWERLITE, ENGINE REMOVAL
1. Use a pump type siphon to remove the fuel from
the fuel tank.
2. Remove the belt cover from the left side (Figure
46).
Figure 46 1854-35
3. Remove the belt from the engine pulley and
remove the engine pulley and key if so equipped
(Figure 47).
Figure 47 1854-35-2
4. Remove the two screws at the bottom of the
control panel and remove the control panel cover
(Figure 48).
Figure 48 1854-42
(A) Screws
A