Service Manual

Single Stage Snowthrower Service Manual 9 - 23
GAS POWER SHOVEL
REPLACE SCRAPER
The scraper blade located on the bottom of the Power
Shovel should be replaced if worn.
1. Remove the rotor; refer to "PADDLE
REPLACEMENT - STRAIGHT PADDLE" on page
7 - 2).
2. Remove the three screws, six washers, and three
locknuts used to hold the scraper blade (Figure
240).
3. Attach the new scraper blade taking care to hook
scraper over front edge of the housing. Secure
with existing screws, washers and locknuts, and
tighten.
Figure 240 0406-057
STORAGE
1. Refer to "Draining The Fuel Tank" on page 9 - 4.
Complete all steps on page 9 - 4.
2. Remove the spark plug.
3. Next, pour two teaspoons of engine oil into the
spark plug hole.
4. Pull the recoil starter slowly to distribute oil on the
inside of the cylinder.
5. Replace the spark plug.
6. Clean the rotor, rotor housing, and exterior of
Power Shovel. Tighten all screws and nuts. If any
part is damaged, repair or replace it.
7. Store the Power Shovel in a clean dry place and
cover the unit to give it protection. Never store the
unit in the house or basement.