Service Manual

SPECIFICATIONS & MAINTENANCE

2-10

Toro Single Stage Snow Service Manual

Replacing the Drive Belt

If drive belt becomes worn, oilsoaked, excessively

cracked, frayed, or otherwise damaged, replace

the belt.

1. Remove the 4 bolts that hold the drive belt cover

(Fig. 005) in place.

NOTE

The lower front corner of the drive belt cover is fastened

down with a smaller bolt, a washer, and a locknut.

2. Remove the belt from the rotor pulley (Fig. 006).

3. Press down on the idler arm and remove the belt from

between the tab on the idler arm brake and the rotor

pulley.

NOTE

The engine pulley belt guide is very close to the pulley, and

the belt may not t through the gap.

4. Twist the belt out in front of the belt guide so that the

belt is wedged between the belt guide and the

engine pulley.

Fig. 006

A. Rotor Pulley E. Idler Pulley

B. Idler Arm Brake F. Engine Pulley

C. Drive Belt G. Tabs on the Idler Arm

D. Idler Arm

A. Drive Belt Cover

Fig. 005