Service Manual

SPECIFICATIONS & MAINTENANCE

2-16

Toro Single Stage Snow Service Manual

NOTE

After extended use, the drive belt may wear and lose its

proper belt tension. If the drive belt slips (continuously

squeals) under a heavy load,disconnect the spring from

the adjustor link and move the upper end of the spring to

the hole that is further from the pivot point in the control

bar (Fig. 011). Then connect the spring to the adjustor link

and adjust the control cable.

NOTE

The belt may slip (squeal) in wet conditions; to dry out the

drive system, start the rotor and run it without a load for

30 seconds.

A. Remove the upper end of spring from this hole

B. Insert the upper end of spring into this hole

C. Pivot point

D. Upper end of spring

Fig. 011