Service Manual

Adjusting the Quick
Shoot
™
Control
If there is more than 1/2” (13mm) of slack in the
Quick Shoot cable (Fig. 023) or the discharge chute does
not rotate left and right in equal angles, adjust the Quick
Shoot control cables.
1. Loosen the two Quick Shoot control cable clamps
(Fig. 024).
SPECIFICATIONS & MAINTENANCE
2-22
Toro Single Stage Snow Service Manual
A
Fig. 024
A
Fig. 023
2. Position the Quick Shoot control between the two
arrows located on the right hand side of the upper
handle (Fig. 025).
3. Rotate the discharge chute so that it faces straight
ahead and the arrow on the back of the discharge
chute aligns with the arrow on the shroud (Fig. 026).
A
Fig. 025
A. 1/2” (13mm) maximum slack
A. Cable Clamps
A. Arrows
Fig. 026