Service Manual

Engine Installation 21 Inch Models
ENGINE MOUNTING
5-8
Toro Single Stage Snow Service Manual
1. Insert the engine into the chassis. Install the four
engine mounting bolts that secure the engine to the
engine plate (A). Torque to 14-18 ft-lbs (19-25 Nm)
(Fig. 019).
2. From the underside of the chassis, install the two
engine mounting bolts (A). Torque to 14-18 ft-lbs
(19-25 Nm) (Fig. 020).
Fig. 020
A
A
3. Install the engine pulley. If the unit has a bolt holding
the engine pulley on, torque the bolt to 19 ft-lbs (26
Nm). If the unit has set screws, slide the pulley onto
the shaft and install the belt. With a straight edge,
align the pulley with the rotor pulley so the belt is
straight.Tighten set screws (Fig. 021).
4. Connect the primer hose to the primer bulb and plug
the ignition wires into the ignition switch (Fig. 022).
Fig. 021
Fig. 022
Fig. 019
A
A
A
A