Service Manual
CHASSIS
3-19
Toro Single Stage Snow Service Manual
9. Insert the barrel of the grey cable into its slot in the
gear. Secure the cable under the tabs in the gear
(Fig. 029).
10. Route the cable around the top of the spool (Fig. 030).
11. When the cables are routed correctly the cables and
gear should look like this (Fig. 031).
12. Slide the gear into the pinion bracket and secure the
cable locks (Fig. 032).
13. Align the quick chute control and the discharge chute
asoutlinedinthespecicationsandmaintenance
chapter. Insert the pinion spacer sleeve and insert
the pinion and bracket assembly as shown. Tighten
bolt to 8 ft-lbs (11 Nm) (Fig. 033).
NOTE
Do not overtighten!
Fig. 029
Fig. 030
Fig. 032
Fig. 031
Chassis
3
Fig. 033