Operator's Manual

3351-827 Rev A

Product Overview

m-6199a

1. Discharge chute

2. Chute handle

3. Control bar

4. Handle

5. Control panel

6. Knobs

7. Handle bolt (2)

8. Rotor blade

9. Fuel tank cap

mĆ5544

1. Key switch

2. Primer

3. Recoil start

4. Choke lever

Setup

Unfolding the Handle

1. Cut the plastic tie that secures the control cable

to the handle.

Note: Hold the cable taut to ensure that it stays

disconnected at the bottom.

2. Loosen the knobs, pull out the handle bolts, and

rotate the upper handle to the operating position.

m-6103a

3. Hook the end

of the control

cable into the

bottom hole of

the control bar.

m-6105

4. Fully insert the handle bolts.

Important:

Ensure that you

do not pinch the

control cable.

5. Tighten the

knobs until they

are snug.

m-6104a

6. Adjust the control cable. Refer to Adjusting the

Control Cable on page 10.