Service Manual

SPECIFICATIONS & MAINTENANCE
2-9
Walk-Behind Rotary Broom Service Manual
Checking the Broom Cable
SERVICE INTERVAL
After the rst 2 hours, Yearly.
1. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
2. Remove the belt cover and engine shield.
3. With the broom lever disengaged, ensure the gap
between the broom clutch assembly and the tab is
1/8” (3.2 mm). If the broom is not properly adjusted,
see “Adjusting the Broom Drive” (page 2-11).
Checking the Broom Shaft
Shear Pin
SERVICE INTERVAL
Before each use or daily.
1. Move the machine to a level surface.
2. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
3. Check the shear pin located on the broom shaft on
either side of the gear box.
4. If the shear pin is damaged, remove the pin and
replace with a Toro recommended pin. Secure the
pin with a nut.
Fig. 008
Fig. 007
A. Broom Clutch Assembly
B. Tab
C. 1/8” (3.2 mm)
A. Nut
B. Shear Pin
A
B
C
A
B
Specications & Maintenance
2