Service Manual

Traction Cable Adjustment

1. The traction lever should be in the full upright

position with some slack in the traction cable to

begin adjustment.

2. Adjust using the turnbuckle (A). Hold the cable to

prevent twisting.

3. Locate the traction rod on the left side just below the

belt cover. Adjust the cable turnbuckle until there is

a slight gap between the end of the rod and the front

of the slot maximum 1/16” (1.5 mm). Secure the jam

nut on the turnbuckle.

CONTROLS

3-6

Walk-Behind Rotary Broom Service Manual

Fig. 010

Clutch Cable Replacement

Removal

1. To replace the clutch cables, drain the fuel tank

remove broom and stand the machine forward onto

the hood. Remove both lower covers. The wheels

and the bottom cover can also be removed

if desired.

2. Remove the nut and washer that attach the cable

clamp to the handle.

3. Slip the cable Z-bend out of the wheel clutch lever

on the handle.

Fig. 011

Fig. 012

Fig. 013