Service Manual

CONTROLS
3-8
Walk-Behind Rotary Broom Service Manual
4. Pull the cable jacket down gently until the wheel
clutch lever is down and the slack is out of the cable.
Tighten the cable clamp nut securely.
5. Squeeze the lever fully and check the gap between
the bottom of the handle and the wheel clutch lever
end. The gap should be approximately 1/4” (6mm).
If it is greater, loosen the cable clamp nut, slide the
cable jacket up slightly, tighten the cable clamp nut,
and check the gap again. Repeat steps for the
other cable.
6. Install the covers and test run the unit.
Fig. 018
Fig. 019