Service Manual

6. Install the auger belt and install the pulley sheave.
Make sure that the keyways line up from the sheave
to the pulley. If they are not aligned the sheave will
break when tightening.
7. Install the belt guide. Check for proper clearance
between the belt and the belt guide. Engage the
auger belt and look between the belt and belt guide
on the left side. There should be about a 1/8”
(3.2mm) gap. Tighten the belt guide mounting bolts
to 19 ft - lbs (26 Nm).
8. Adjust the belts as needed as outlined in the
Controls section.
BELT REPLACEMENT
4-6
Walk-Behind Rotary Broom Service Manual
Fig. 012