Service Manual

Sub System Clutch Drive
TRACTION DRIVE SYSTEM
5-3
Walk-Behind Rotary Broom Service Manual
Fig. 002
A. RH Wheel and Tire Asm. I. Shaft - Intermediate
B. Wheel - Friction J. Collar - Shift, LH
C. Bearing - Axle K. Shaft - Axle
D. Guide - Collar L. Gear - Axle, 44 Tooth
E. Lit Gear Asm. M. Tube - Axle
F. Chain - Roller N. LH Wheel & Tire Asm.
G. Link - Connector O. Shaft - Hex
H. Collar - Shift, RH P. Sprocket 8 Tooth
1
Apply light coat of oil hex portion of shaft.
Hex trunion must slide freely along hex shaft.
2
Assemble sprocket ush against shoulder on shaft.
3
Install chains with master link clip toward center of
machine. Closed end of master link to be in direction
of rotation going forward.
4
Torque screws to 50 - 70 in - lbs (6 - 8 Nm).
Do not deform plastic.
5
Grease axle gears.
6
Add anti sieze before installation of axle shaft.
7
Axle to be installed in bottom hole of axle bearing.
8
Rotate shift collars fully to the stop. Insure
smooth operation, check each of 6 pawls to
insure they return fully when shift collar is
released.
9
A
B
C
D
E
F
G
H
I
J
L
K
M
N
P
1
1
2
9
5
6
7
7
8
8
6
O
3
4
Traction Drive System
5