Service Manual

TRACTION DRIVE SYSTEM
5-7
NOTE
Install a washer and screw into each end of the shaft to
keep the parts from sliding off.
10. Remove both hairpins located on either side of the
axle of the 44-tooth gear.
11. Remove the woodruff key from one side of the axle
shaft by sliding the 44-tooth gear inward towards the
center of the shaft to expose the woodruff key. Pry
up on the outside edge of the key to remove it.
12. Slide the axle shaft out through the bearing retainer
one at a time, holding onto the 44-tooth gear.
13. Slide the tube of the axle shaft through the housing.
14. Remove the other half of the axle shaft with the
44-tooth gear.
Fig. 014
Fig. 016
Fig. 017
Fig. 015
Walk-Behind Rotary Broom Service Manual
Fig. 018
Fig. 019
Traction Drive System
5