Service Manual

TRACTION DRIVE SYSTEM

5-19

Walk-Behind Rotary Broom Service Manual

9. Remove the retainer plate off the gear hub.

10. Remove the pawl pins and pawls from the

32-tooth gear.

11. Repair or replace components as needed.

Fig. 075

Wheel Clutch Assembly

NOTE

Apply a light coat of SAE 30W oil to the intermediate

shaft before assembly.

1. Set the 32-tooth gear on a at surface and install the

pawls. Apply a light coat of oil to the dowel pins and

install the dowel pins into the pawl assembly.

2. With the pawls facing up and away from the hub,

slide the retainer plate onto the hub. Make sure the

pins are seated ush and the retainer plate sits ush

onto the gear.

Fig. 076

Fig. 074

Fig. 077

Fig. 078

Traction Drive System