Service Manual

Adjusting Broom Side Angle

1. Disengage the broom and stop the engine.

2. Wait for all moving parts to stop.

3. Push the lever down using the right hand thumb (A)

(Fig. 003).

4. Squeeze the left wheel clutch lever to the handle

and push the broom housing to the desired angle;

the broom can rotate 19° to the right or left, or

straight ahead.

5. Once the broom is positioned, release the broom

angle lever. Release the left wheel clutch lever and

make sure the broom is locked into place.

Adjusting the Broom Height

1. Drive to a at dusty area and stop the machine.

2. Disengage the broom and stop the engine.

3. Wait for all moving parts to stop before leaving the

operating position.

4. Turn the engine On/Off switch to the Off position.

5. To adjust the broom height, remove and retain the

pin from the adjuster sleeve and caster wheel tube.

6. Raise or lower the caster wheel tube to achieve the

sweep area as stated in “Checking the Sweeping

Path” (page 2-3). Select any hole combination

that is in alignment to place and latch the retaining

pin; match the same position on the other side.

7. For ne tuning adjustments, slide the adjuster sleeve

one pin hole up or down on the caster wheel tube to

adjust the broom height in 1/8” (3 mm) increments

(Fig. 002). Repeat for the other caster wheel.

• To raise the broom in 1/8” (3 mm) increments,

slightly raise the adjuster sleeve and insert the pin

into the next pin hole below the current hole used.

• To lower the broom in 1/8” (3 mm) increments,

slightly lower the adjuster sleeve and insert the pin

into the next pin hole above the current hole used.

8. Once the desired height is reached, secure the pin

on each caster wheel. Recheck the sweeping area.

A. Caster Wheel Tube

B. Positions To Achieve 1/8” (3 mm) Increments

C. Pin

D. Adjuster Sleeve

2-4

Walk-Behind Rotary Broom Service Manual

SPECIFICATIONS & MAINTENANCE

Fig. 002

Fig. 003