Service Manual

Filament Replacement
6
BROOM HEAD
6-7
Walk-Behind Rotary Broom Service Manual
4. Repeat this procedure for the opposite side of the
broom shaft.
5.  Placethebroomassemblyontheoorsothatthe
gearboxshaftisclosesttotheoor.
6. Apply silver grade anti-seize to gear box splined
shaft end. Slide the broom back into the machine
just far enough to install the drive shaft into the
spline coupler.
7. Lift the handles to align the broom frame with the
broom shaft. Install the pillow blocks around the
bearing.
8. Install the carriage head bolts from the inside of the
frame, frist through the pillow block plates, then into
the frame. Loosely install the nuts. Repeat for the
other side. Torque pillow block bolts to 26 ft - lbs
(36 Nm).
Fig. 011
Fig. 012