Operator's Manual

3.Manuallypullthepowerunitrearwardtoremove
thebroomassemblyfromthemachine.
4.Supportthesplineshaftoneithersideofthe
gearbox.
5.Standthebroomcoreassemblyonendsothat
theendretainerplatefacesupward(Figure38).
g326889
Figure38
1.Hardware
4.Supportshaft
2.End-retainerplate
5.Alignmentngers
3.Broomsegment
6.Removeandretainthehardwarefromthe
end-retainerplate(Figure38).
7.Removethedamagedbroomsegment(s).
8.Installthenewsegment(s)bystaggeringthe
metalringalignmentngersasshowninFigure
38.
Important:Youmaydamagethebroom
assemblyifyoudonotproperlyinstallthe
broomsegments.
9.Installthebroomassemblyontothemachine.
Important:Makesurethatthebearing
setscrewsaretightenedbeforeoperatingthe
broom.
CheckingtheBroomDrive
Adjustment
ServiceInterval:Aftertherst2hours—Checkthe
broomdriveadjustmentandcorrect
itifnecessary.
Yearly—Checkthebroomdriveadjustmentand
correctitifnecessary.
1.Removethebeltcover;refertoRemovingthe
BeltCover(page26).
2.Withthebroomdriveleverdisengaged,ensure
thatthegapbetweenthebroomclutcharmand
theframeofthemachineis1.5mm(1/16inch)
asshowninFigure39.
Important:Ifthegapbetweenthebroom
clutcharmandtheframeistoosmallortoo
large,adjustthebroomdrivecable;referto
AdjustingtheBroomDriveCable(page26).
g326890
Figure39
1.1.5mm(1/16inch)gap
3.Broomclutcharm
2.Frame
3.Ifthegapbetweenthebroomclutcharmand
theframeis1.5mm(1/16inch),installthebelt
cover;refertoInstallingtheBeltCover(page
26).
25