Service Manual

TRACTION DRIVE SYSTEM
5-8
15. Remove the two screws from the shift rod bracket
and remove the traction control lever and bracket
assembly from the friction wheel.
16. Remove the bearing retainer that holds the
hex shaft (if not previously been done).
17. Remove the hex shaft assembly/friction wheel from
the housing.
18. Remove the friction wheel from the hex shaft by
removing the three nuts and bolts that hold the
friction wheel to the plate on the hex shaft.
19. Move the unit to the upright position and remove the
belt cover.
Fig. 020
Fig. 023
Walk-Behind Rotary Broom Service Manual
Fig. 021
Fig. 022
Fig. 024
Fig. 025