Service Manual

ManualsBrandsToro ManualsGas Snow BlowersPower Clear 721 R-C 21 in. 212 cc Commercial Single-Stage Self Propelled Gas Snow Blower

Table Of Contents

Revision History
Preface
- Service Procedure Icons
Chapter 1 : Safety
- Safety Instructions
  - Think Safety First
Chapter 2 : Specifications and Maintenance
- Specifications
- Torque Specifications
  - Equivalents and Conversions
  - U.S. to Metric Conversions
Chapter 3 : Troubleshooting
- General Troubleshooting
- Engine Model/Serial Number Location
Chapter 4 : Starter System
- General Information
- Service and Repairs
  - Recoil Replacement
Chapter 5 : Fuel System
- General Information
- Service and Repairs
Chapter 6 : Governor Controls
- General Information
- Service and Repairs
  - Speed Control Assembly Replacement (G210–1, G210–2, & G210–4)
  - Governor Arm Replacement (G210–1, G210–2, & G210–4)
Chapter 7 : Compression System
- General Information
- Service and Repairs
  - Cylinder Head Replacement (G210–1, G210–2, & G210–4)
  - Piston and Connecting Rod Replacement
Chapter 8 : Electrical
- General Information
- Service and Repairs
Chapter 9 : Engine Lower End
- General Information
- Service and Repairs

G210–2&G210–4FlywheelInstallation(continued)

g328424

Figure269

6.Usingastrapwrenchtokeeptheywheelandcrankshaftfromturning,install

the(M6)angenuttothecrankshaft.T orquethenutto85N•m(63ft-lb).

Note:Donotlubricatethecrankshaftorthreadsoftheangenut.

7.Looselyinstallthe2(M6x25)screwssecuringtheignitioncoiltotheengine

block.Slidetheignitioncoiltotheendoftheslotawayfromywheeland

tightenthescrews.

g328136

Figure270

8.Usinganon-metallicfeelergauge,adjusttheairgapbetweentheignition

coilandtheywheelto0.4mm(0.016inch).Torquethescrews10N•m

(89in-lb).

G210EngineServiceManual

Page8–31

Electrical:ServiceandRepairs

3439-732RevA