Service Manual

3-3Power Max Service Manual

To remove the fuel tank, unscrew the gas cap, slip the

tank out of the shroud and install the cap. If there is

fuel in the tank, clamp the line, or drain the tank into a

suitable container. Remove the fuel line and fuel ﬁ lter.

The tank is held in place by the bracket and shroud

surrounding it (Fig. 007).

Fuel Tank, Fuel Line and Fuel Filter

Fig 007 MVC-000

The primer line connects to the back side of the primer

then is routed over the fuel line, over the foam block

(Fig. 008).

Fig 008 MVC-865XA

1. Ensure the ignition switch is in place and the wire

harness is plugged in, the primer line is attached to

the primer and the primer body is secure in its slot,

and the fuel tank, fuel line and ﬁ lter are properly

installed.

Fig 009 MVC-866XA

It should be gathered and secured to the ignition switch

wires. It then goes down to the primer ﬁ tting on top of the

carburetor (Fig. 009).

ENGINE

Primer Line Routing

Engine Shroud Assembly