Service Manual

4-8 Power Max Service Manual

CONTROLS

Deﬂ ector Cable Adjustment

Make sure the Quick Stick is in the maximum rear

position and centered (Fig. 037); ensure the deﬂ ector

is in the full upward position. Draw the slack out of the

cable and secure the clamp (Fig. 036).

Fig 037 MVC-775X

The shift lever on the control panel is connected to the

friction wheel in the traction drive by a shift rod. Moving

the shift lever moves the friction wheel to change wheel

direction and speed (Fig. 038).

Fig 038 MVC-901XA

Fig 040 MVC-560F

2. Pull the shift rod and arm upward as far as they will

go. With the shift lever in R2, adjust the trunion to

take the slack out and resecure (Fig. 040).

Note: Excessive slack in the linkage may cause the

drive to be in reverse when shifted into ﬁ rst

gear.

Fig 039 MVC-561F

1. The adjustment point is a trunion on the upper end

of the shift rod (Fig. 039).

SHIFT LEVER

Shift Rod Adjustment