Service Manual

4-12 Power Max Service Manual

CONTROLS

Assembly

2. Remove nut and washer that attach the cable clamp

to the handle (Fig. 051).

Fig 051 MVC-889XYL

3. Slip the cable Z bend out of the wheel clutch lever

on the handle.

4. Reach under the shift plate and compress the small

ears on the cable ﬁ tting (Fig. 052). The cable ﬁ tting

can then be pushed out of the shift plate.

Fig 052 MVC-899X

Fig 054 MVC-878XYZ1

1. Feed the lower end of the cable through the shift

plate and snap the cable into the plate. Install the

lower end of the cable into the shift collar outside in,

as shown (Fig. 054).

Fig 053 MVC-898XB

5. Disconnect the lower end of the cable from the shift

collar (Fig. 053).