Service Manual

5-1Power Max Service Manual

BELT REPLACEMENT

1. To replace the belts begin by removing both belt

covers (Fig. 058). (On 2-cycle models only, remove

3 screws holding the front half of the engine shroud

to the chassis and the rear shroud. The belt cover

slides under the front of the engine shroud so this

will make belt cover removal much easier.)

Fig 058 MVC-006XB

2. Remove the belt guide. Be careful to avoid bending

the guide (Fig. 059).

Fig 059 MVC-007F

Fig 061 MVC-067X

4. The brake assembly can be lifted out of the chassis

(Fig. 061).

Fig 060 MVC-1883X

3. Remove the brake assembly for more working room.

Disconnect the spring, then remove the two bolts

through the side plate (Fig. 060).

AUGER BELT

A. Spring C. Bolts

B. Brake Assembly

A. Brake Assembly