Service Manual

9-12 Power Max Service Manual

WHEEL CLUTCH

TRACTION DRIVE SYSTEM

9. Make sure the axle bearing end that is holding the

axle shaft is on the bottom (Fig. 157).

Fig 157 MVC-857X.jpg

10. 44-tooth gears should have hub facing inward (Fig.

158).

Fig 158 MVC-871XYZ.jpg

11. Slide one end of the axle shaft with tube into the

housing (Fig. 159).

Fig 159 MVC-052X.jpg

A. Hub

Fig 160 MVC-056X.jpg

12. With the woodruff key out of the other side of the

shaft as well as all the other components, install

axle bearing onto housing and then slide the shaft

in though the bearing and housing, through the two

washers and 44-tooth gear sprocket into the tube

(Fig. 160).