Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
TractionDriveSystemRemoval(AutoturnModels)(continued)
Figure67
12.Removethestubshaft,transmission,andaxlefromthemachine.
Figure68
TractionDriveSystemInstallation(AutoturnModels)
1.Installtheaxle,transmission,andstubshaftontothemachine.
2.Placetheaxleintopositiononthehousing.
3.Slidetheaxlebearingintoposition.
4.Installthesnapringsecuringtheaxlebearingtothehousing.
5.Installthehexshaftandfrictionwheels.
6.Installbothbearingretainers.Installthe2screwssecuringthebearing
retainersandhexshafttoeachsideofthetractionassembly.
7.Installthe4screws(2perside)securingtheintermediateshafttothehousing.
8.Installbothwheelkeysandwheels.
WheelClutchTractionDriveSystem:ServiceandRepairs
Page9–14
POWERMAX®HDServiceManual
3424-820RevA