Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
WheelClutchReassembly(continued)
3.Clamporholdthegearandturnitovertoproperlyinstallthe3pawlsupports
andtorxscrews.
4.TorquetheT-27torxscrewsto100–125in-lbs.(11.3–14.1Nm).
5.Installthe4guidecollarstotheshaftwiththeshiftbraceplate.
Figure75
6.Torquethescrewsto50–70in-lbs.(5.65–7.9Nm).
7.Slidetheatwashersintopositionnexttotheguides.
8.InstalltheRIGHTandLEFTcollarintoposition.
Note:Thetopangesoftheshiftcollarshave“left”and“right”stamped
intothem.Installaccordinglyontherightandleftendsoftheshaftwiththe
shiftbraceplateorientedasshown.
Figure76
9.Installthecompressionspringsunderthepawls.
10.Slidethethrustwasherontothe32–toothsprocket.
WheelClutchTractionDriveSystem:ServiceandRepairs
Page9–18
POWERMAX®HDServiceManual
3424-820RevA