Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
AugerBeltInstallation(continued)
6.Installthepulleyandtheaugerbelttothecrankshaft.ApplyLoctite243(blue)
tothebolt.Installtheboltsecuringtheenginepulleytothecrankshaft.
7.Installthebeltguide.
CAUTION
Whentighteningthecrankbolt,theenginemustbecrankedto
preventpinchingthetractionbeltbetweenthepulleysheaves.
Failuretodosowilldamagethetractionbeltandcrankboltwillhave
alowtorqueuponrstuse.
TractionBeltReplacement
TractionBeltRemoval
1.Removethefuelfromthemachine.
2.Removethebeltguide.
3.Removethecrankbolt.
4.Removetheimpellerpulley.
5.Removethebeltfromthecrankshaftpulley.
6.Tiptheunitonthefront.
7.Removethebeltfromthelowerpulley.
Figure39
TractionBeltInstallation
1.Installthebelttothelowerpulley.
2.Tiptheunitbackintoproperposition.
3.Installthebelttothecrankshaftpulley.
4.Checkforproperclearancebetweenthebeltandbeltguide.Engagethe
augerbeltandlookbetweenthebeltandbeltguideontheleftside.There
shouldbeabout1/8in.(3.2mm)gap.Tightenthebeltguidemountingbolts.
Belts:ServiceandRepairs
Page6–6
POWERMAX®HDServiceManual
3424-820RevA