Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
SeparatingtheAugerandTractionAssemblies(continued)
Figure48
11.Onceseparated,theaugerpulleyisintheopen.
12.Removethepulleyfromtheinputshaft.
13.Removethe4housingboltsontheoutsideoftheaugerhousing.
14.Slidethegearcase,augers,andimpellersoutofthehousing.
AugerGearBoxReplacement
AugerGearBoxInstallation
1.Applyathincoatofanti-seizetotheaugershaftsandtheimpellershaft.
Installtheimpellerandaugers,securewithcapscrewsandlocknuts.Slide
theaugershaftbushingsontheendsoftheaugershaft.
2.Inserttheimpellershaftthroughthebearingontherearoftheaugerhousing.
Thebearingmountingboltsshouldbeslightlyloose.
3.Securetheaugershaftbushingstotheaugersideplateswith4capscrews
(2perside).
4.Applyalightcoatofanti-seizetotheimpellershaftandinstalltheimpeller
pulley.Pushtheaugershafttotherearandpushthepulleyforwardand
secure.Thereshouldbe1/8in.(3mm)fronttobackmovementontheshaft.
AugerGearbox:ServiceandRepairs
Page8–6
POWERMAX®HDServiceManual
3424-820RevA