Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
ControlInterlockRemoval(continued)
Figure23
5.Oncetherollpinsaredrivenout,thelockoutrodcanbemovedtotheside
andremoved.Thelockoutlinkcannowberemovedfromthelockoutrod.
6.Removethelevers.
Note:Steps1and2above,donotneedtobedoneinthatorder.It’spossible
toremovetherodwithoutremovingtheshoulderbolt.
Figure24
ControlInterlockInstallation
Note:Noticethespringonthelockoutlatch.Theendwiththeslightbendgoes
behindthelockoutlatchandthehookedendgoesoverthesmalltab.Itiseasier
toinstallthelatchmechanismrst,thenhooktheendofthespringwithawire
topullintoplace.
1.Installthetractionleverandtorsionspring.
Controls:ServiceandRepairs
Page5–12
POWERMAX®HDServiceManual
3424-820RevA