Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
WheelClutchDisassembly(continued)
Figure73
8.Removethe6(perside)T-27torxscrewsthatsecurethepawlretainerplate.
9.Removetheretainerplateoffofthesprockethub.
Figure74
10.Removethepawlpinsandpawlsfromthe32–toothsprocket.
11.Repairorreplacedefectivecomponents.
WheelClutchReassembly
Note:ApplyalightcoatofSAE30Woiltointermediateshaftbeforeassembly.
1.Setthe32–toothsprocketonaatsurfaceandinstallthepawls.
2.Withthepawlsfacingupandawayfromthehub,slidetheretainerplate
ontothehub.Makesurethepinsareseatedushandtheretainerplate
sitsushontothegear.
POWERMAX®HDServiceManual
Page9–17
WheelClutchTractionDriveSystem:ServiceandRepairs
3424-820RevA