Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
ChuteandFaceGearCoverRemoval(continued)
Figure85
5.Removethechute.
ChuteandFaceGearCoverInstallation
1.Installthechute.Securewithaboltonthefacegear.
2.Installthefrontofthecoverintoposition.Securewithascrew.
ChuteGearReplacement
ChuteGearRemoval
1.Parkthemachineonalevelsurface.Stoptheengine,waitforallmoving
partstostopandremovethekey.
2.Removethescrewonthefacegearcover.
3.Raisethefrontofthecoverandslidetowardstherear.
4.Removethelocknutfromthebottomofthe3shoulderscrews.
5.Disconnectthelatchcablefromthecableanchor.
6.Raisethefrontofthefacegearandslidetowardsthechuterod.
7.Removetheshoulderboltfromthechutegear.
8.Removethe2screwssecuringthegeartothebracket.Removethegear.
Note:Aplasticspacerisunderthebracket.
ChuteGearInstallation
1.Attachthechutegeartothebracket.Securewith2screws.
2.Placethespacersideuponthesupporttube,thensetthegearandbracket
downonit.Theshoulderboltgoesthroughandissecuredwiththewasher
andlocknut.
3.Slidethefacegearmountonthechuterod,ifremoved.Slidethefacegear
onthechuterod.
4.Thefacegearhasaribmoldedintoitandthechutegearhas2.Lineupthe
ribsandplacethefacegearmountontothesupporttube.
POWERMAX®HDServiceManual
Page10–5
DischargeChute:ServiceandRepairs
3424-820RevA