Use and Care Manual
Table Of Contents
- NO TITLE
- NO TITLE
- .
- ? Installing the Upper Handle
- ? Installing the Wheel-Clutch-Cable Ends
- ? Installing the Traction-Control Linkage
- ? Installing the Chute-Control Rod
- ? Connecting the Headlight and Handwarmer Wires to the Engine
- ? Installing the Snow-Cleanout Tool
- ? Checking the Engine-Oil Level
- ? Checking and Adjusting the Tire Pressure
- ? Checking the Skids and Scraper
- ? Checking the Operation of the Traction Drive
- NO TITLE
- NO TITLE
- NO TITLE
- .
- Maintenance Safety
- Preparing for Maintenance
- Checking the Engine-Oil Level
- Checking and Adjusting the Skids and Scraper
- Checking and Adjusting the Traction Cable
- Checking and Adjusting the Auger/Impeller Cable
- Checking the Auger-Gearbox-Oil Level
- Changing the Engine Oil
- Lubricating the Hex Shaft
- Replacing the Spark Plug
- Adjusting the Discharge-Chute Latch
- Replacing the Drive Belts
- Replacing the Headlight Bulb
- NO TITLE
- NO TITLE
g037221
Figure22
Temperature
SuggestedNumberof
Primes
Above-18°C(0°F)
3
-23°Cto-18°C(-10°Fto0°F)
4
Below-23°C(-10°F)
6
5.MovethechoketotheCHOKEposition(Figure
23).
g016501
Figure23
6.MovethethrottletotheFASTposition(Figure
24).
g016504
Figure24
7.Startthemachinebypullingtherecoilstarteror
pressingtheelectric-starterbutton(Figure25).
g019055
Figure25
1.Electric-starterbutton3.Recoil-starthandle
2.Electricstarterplug-in
Note:Useonlyanextensioncordthatis
UL-listed,16gauge,notlongerthan15m(50
ft),andisdesignedforoutdooruse.
WARNING
Theelectricalcordcanbecomedamaged,
causingashockorre.
Thoroughlyinspecttheelectricalcord
beforeusingthemachine.Ifthecord
isdamaged,donotuseit.Replaceor
repairthedamagedcordimmediately.
ContactanAuthorizedServiceDealerfor
assistance.
Important:Topreventdamagingtheelectric
starter,runitinshortcycles(5secondson,
5secondsoff),nomorethan10times.Ifthe
12