Use and Care Manual
Table Of Contents
- NO TITLE
- NO TITLE
- .
- ? Installing the Upper Handle
- ? Installing the Wheel-Clutch-Cable Ends
- ? Installing the Traction-Control Linkage
- ? Installing the Chute-Control Rod
- ? Connecting the Headlight and Handwarmer Wires to the Engine
- ? Installing the Snow-Cleanout Tool
- ? Checking the Engine-Oil Level
- ? Checking and Adjusting the Tire Pressure
- ? Checking the Skids and Scraper
- ? Checking the Operation of the Traction Drive
- NO TITLE
- NO TITLE
- NO TITLE
- .
- Maintenance Safety
- Preparing for Maintenance
- Checking the Engine-Oil Level
- Checking and Adjusting the Skids and Scraper
- Checking and Adjusting the Traction Cable
- Checking and Adjusting the Auger/Impeller Cable
- Checking the Auger-Gearbox-Oil Level
- Changing the Engine Oil
- Lubricating the Hex Shaft
- Replacing the Spark Plug
- Adjusting the Discharge-Chute Latch
- Replacing the Drive Belts
- Replacing the Headlight Bulb
- NO TITLE
- NO TITLE
3.Graspthecableconduitandmoveittowardthe
frontofthemachineuntilthedischarge-chute
latchfullyengagesthegearteeth(Figure53
andFigure54).
g001032
Figure54
1.Discharge-chutelatch
2.Gearteeth
Note:Thelatchisspringloadedandnaturally
movesintotheteethofthegear(Figure54).
4.Removeanyslackinthecablebypullingthe
cableconduitrearward.
5.Tightentheboltonthecableclamp,being
carefulnottostriptheplasticpart.
6.Installandsecurethegearcover.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetraction-drivebelt
becomesworn,oil-soaked,orotherwisedamaged,
haveanAuthorizedServiceDealerreplacethebelt.
ReplacingtheHeadlight
Bulb
UseaTorolightbulborequivalent(GE89937W
halogenbulb).Donottouchthebulbwithyourhands
orallowdirtormoisturetocomeintocontactwiththe
bulb.
1.Removethewireconnectorfromthebackofthe
headlight(Figure55).
g001037
Figure55
2.Turnthebaseofthebulbcounterclockwiseuntil
itstops(Figure56).
g001033
Figure56
3.Removethebulbstraightoutfromthebackof
theheadlight(Figure57).
g001034
Figure57
4.Insertanewbulbintothebackoftheheadlight
(Figure58).
g001035
Figure58
5.Turnthebaseofthebulbclockwiseuntilitis
snug(Figure59).
g001036
Figure59
6.Insertthewireconnectorstraightintothebackof
theheadlightuntilitissecurelyinplace(Figure
60).
24